Austin A40 Devons
The A40 Devon (and similar 2-door A40 Dorset) were automobiles marketed by the Austin Motor Company from 1947 to 1952 – the first post-war saloons to be produced by Austin – featuring a mix of old and new technologies. Austin manufactured more than 450,000 examples before replacement in 1952 by the Austin A40 Somerset.
Mechanicals and bodystyles[]
Both the Devon and Dorset were body-on-frame designs with modern bodies and a 1.2 L straight-4 OHV engine producing 40 bhp (30 kW) at 4200 rpm. They also featured front coil sprung independent suspension but retained a rigid axle and semi elliptic leaf springs at the rear. The Girling brakes with 9 in (229 mm) drums were operated hydraulically at the front and mechanically at the rear. Later cars had column operated gear change and full hydraulic braking. A sliding sunroof and heater were extra cost options on the UK market.
The Devon was the 4-door version and was more successful than the 2-door Dorset, which was dropped in 1949 after only 15,939 were made.
The "Countryman" estate was produced up until 1956. A van and pickup truck were also produced.
A prototype A40 Dorset Tourer was built at Longbridge in 1948. Although it was never put into production in England, various versions of the A40 Tourer were made in Australia beginning in September 1948.
- Austin A40 Devon
- Austin A40 Devon Tourer
- Austin A40 Countryman
- Austin A40 Van
Performance[]
A car tested by The Motor magazine in 1948 had a top speed of 70 mph (110 km/h) and could accelerate from 0-60 mph (97 km/h) in 37.2 seconds. A fuel consumption of 34.1 miles per imperial gallon (8.28 L/100 km; 28.4 mpg-US) was recorded. The test car, which had the optional sliding roof, cost £505 including taxes.
Austin A40 Sports[]
Austin A40 Sports, ca 1951, designed by Eric Neal of Jensen Motors, manufactured in conjunction with Jensen Motors, and based on Austin A40 Devon mechanicals.As one in a series of collaborations between Austin and Jensen Motors of West Bromwich, the A40 Sports originated when Austin's Chairman Leonard Lord, upon seeing the Jensen Interceptor, requested that Jensen develop a body that could use the Austin A40 Devon mechanicals. The center section of the chassis was boxed to provide rigidity for the open body, and the A40 Sports also employed a twin-SU carburetored version of the 1.2 L engine producing 46 bhp (34 kW) rather than 42 bhp (31 kW). During production, A40 Sports bodies were built by Jensen and transported to Austin's Longbridge plant for final assembly, with approximately 4,011 examples manufactured.
Gallery[]
.JPG "Haverhill 2018 (25).JPG (2.94 MB)")